Ground loops and vehicle detection
Control Services of WNY installs, tests, and replaces ground loops and vehicle detection for commercial gates across New York State. Loops tell the gate operator a vehicle is present, so the gate opens for exiting traffic, stays open while a vehicle is in the opening, and does not close on it.
What a ground loop does
A ground loop is a loop of wire laid into a saw cut in the pavement and connected to a detector in the gate operator. When a vehicle passes over it, the detector senses the change and signals the operator.
Where a loop sits decides its job. The same wire can open the gate, hold it, or keep it from closing, depending on where it is cut and how the operator is set up.
The jobs loops do at a gate
Most commercial gates use more than one loop. Each one covers a different moment in the vehicle's trip through the entrance.
Exit loop
Opens the gate automatically for vehicles leaving the property, so drivers do not need a credential to get out.
Safety loop
Keeps the gate from closing while a vehicle is sitting in the opening.
Shadow loop
Holds a swing gate still while a vehicle is inside the area the gate swings through.
Presence loop
Tells the system a vehicle is at the keypad, reader, or intercom before the gate responds.
Why loops fail
When a loop fails, the gate may refuse to open for exiting vehicles, open with nothing there, or start closing too early. The cause is usually one of these.
Pavement problems
Cracked, heaving, or shifting pavement breaks the loop wire or pulls the saw cut apart.
Freeze and thaw
Water gets into cracks, freezes, and widens them every winter, which is hard on loops across upstate New York.
Lightning and power surges
A surge can damage the loop detector inside the operator even when the loop in the ground is fine.
Bad installation
Loops that are poorly placed, poorly sealed, or wired without care fail early and cause intermittent problems.
Test first, then repair or replace
Sometimes the detector or a connection in the operator is the problem and the loop itself is fine. Testing tells the technician which, before anyone cuts pavement.
When the wire in the ground is broken by failing pavement, the lasting fix is a new loop cut into sound pavement, sometimes after the pavement itself is repaired.
Detection is part of the whole entrance
Loops work alongside the operator's safety devices and the access control at the gate. On integrated systems, license plate recognition cameras identify an approved vehicle as well as detect it, and the gate opens without a card or code.
Designing detection together with the rest of the entrance is what makes the gate behave the way the site expects.
Ground loop questions
How do I know a ground loop has failed?
The usual signs are a gate that will not open for exiting vehicles, opens when nothing is there, or starts closing while a vehicle is in the opening. Detector and wiring problems can cause the same symptoms, so a technician tests before recommending new loops.
Can a ground loop be repaired, or does it need to be replaced?
A bad detector or connection can be repaired. A loop wire broken by cracked or shifting pavement usually needs a new loop cut into sound pavement.
How much does ground loop replacement cost?
It depends on how many loops are needed, the condition of the pavement, the equipment, and the labor. The technician explains the scope before the work is done.
Can you add loops to an existing gate?
A technician checks the operator, the pavement, and how traffic moves through the entrance, then recommends where loops belong and what the operator needs to support them.
Planning a new system, or need service on one you have?
New gates, access control, and cameras start with a site survey. Gate or system down? Call us and you'll hear back within the hour. We're available 24/7.
