Skip to content

Commercial gate and security service across New York State

Control Services of WNY is a statewide perimeter security company that installs, services, and maintains automatic gates, gate operators, access control, and professional security cameras for commercial properties across New York State. The company works regularly along the Albany-to-Buffalo corridor and goes farther when the customer covers travel.

Albany to Buffalo, and farther when needed

Most of the work runs along the Thruway corridor between Albany and Buffalo, through Rochester, Syracuse, Utica, and the communities in between. That is where technicians are on the road most often.

Sites outside that corridor, from the Southern Tier to the North Country and the Hudson Valley, are served when the customer covers travel. The office confirms that before anything is scheduled, so there are no surprises.

What upstate weather does to equipment

Wherever the property is, the same conditions wear on gates, operators, loops, and readers. Preventive maintenance exists because of them.

Snow

Packs into tracks and swing paths and buries safety sensors, so the operator pushes against a load it was not built for.

Ice

Locks hinges, rollers, and chains and coats keypads and readers until they stop responding.

Freezing temperatures

Thicken lubricants, slow motors, and cut the capacity of backup batteries.

Road salt

Corrodes posts, hardware, and the base of pedestals and operators closest to the pavement.

Moisture

Gets into housings, junction boxes, and conduit, where it causes faults that come and go.

Power outages

Storms take down power, and a gate without a backup plan stays wherever it stopped.

The same standard in every region

Every job starts with a site survey, because the right gate, operator, access method, safety equipment, and power setup depend on the site. Equipment is professional grade and hardwired, installed properly, and your staff are trained on it before the job is done.

After installation, Control Services stays on for warranty support, repairs, preventive maintenance agreements with visits in spring and fall, upgrades, and expansion.

Service area questions

What parts of New York State do you serve?

Control Services of WNY is a statewide company. It works regularly along the Albany-to-Buffalo corridor, including Western New York, Rochester and the Finger Lakes, Central New York, and the Capital Region, and serves sites farther away when the customer covers travel.

Do you charge for travel?

The company works regularly along the Albany-to-Buffalo corridor. For locations farther out, the customer covers travel, and the office confirms that with you before the visit is booked.

Which equipment brands do you work on?

Technicians work on HySecurity, Magnetic Autocontrol, DoorKing, LiftMaster, FAAC, Viking, and other professional-grade manufacturers. If you are not sure what you have, send a photo of the operator or its label with your request.

Do you work on residential properties?

The focus is commercial properties of all kinds. The company also takes on select high-end residential work for luxury estates.

Planning a new system, or need service on one you have?

New gates, access control, and cameras start with a site survey. Gate or system down? Call us and you'll hear back within the hour. We're available 24/7.