Skip to content

Commercial gate operator installation

Control Services of WNY installs professional-grade gate operators for commercial properties across New York State, including HySecurity, Magnetic Autocontrol, DoorKing, LiftMaster, FAAC, and Viking. Each operator is chosen after a site survey, sized to the gate, the daily traffic, and upstate weather, and installed with the safety devices, detection, and power protection the entrance needs.

The operator does the heavy lifting

The operator is the motor, drive, and control board that open and close the gate, often many times a day and in every kind of weather. An operator that is too small for the gate or the traffic wears out early and fails at the worst possible time.

Sizing starts with the gate itself, meaning its type, weight, and length, and how many cycles it makes each day. A storage facility gate that opens for every tenant needs a different operator than a back entrance that opens a few times a shift.

What goes into a proper install

Bad installation is one of the common causes of gate failure. These are the parts of the job that decide whether the operator lasts.

Sizing

An operator rated for the gate's weight, length, and daily cycles, with room to spare.

Mounting and alignment

A solid mount, lined up with the gate, so the drive is moving the gate and not fighting it.

Safety devices

Equipment that stops or reverses the gate when something is in its path, placed for the layout of the entrance.

Vehicle detection

Ground loops that open the gate for exiting traffic and keep it from closing on a vehicle.

Power and surge protection

Lightning and power surges take out control boards, so the power and wiring are protected from the start.

Access control tie-in

The keypad, reader, intercom, or plate camera wired to the operator so the whole entrance works as one.

Brands we install

Control Services of WNY installs operators from HySecurity, Magnetic Autocontrol, DoorKing, LiftMaster, FAAC, and Viking, along with other professional-grade manufacturers.

The right choice depends on the gate and how the site uses it, not on putting one brand on every job.

Replacing an aging operator

An operator near the end of a roughly 10 year life, or one that was never right for the gate, keeps generating service calls. At some point the repairs cost more than the replacement.

Replacement is the chance to size the operator correctly, add the detection and safety equipment the entrance should have had, and tie in modern access control.

After the operator is running

Every install ends with training on how the gate and its controls work. After that comes warranty support, service and repairs, preventive maintenance, and upgrades as the site changes.

Parts carry the manufacturer's warranty, HySecurity operators include a 5-year parts warranty, and Control Services covers its labor for 90 days. Maintenance visits in spring and fall keep the operator working well past that.

Gate operator installation questions

How do you decide which gate operator to install?

A site survey looks at the gate type, weight, and length, how many times it cycles each day, the power available, and the access method. The operator is chosen to fit all of those, not the other way around.

How much does a gate operator installation cost?

It depends on the operator, the gate, the site work, the safety and detection equipment, and the labor. A site survey comes before the proposal so the scope is clear before you commit.

How fast can you install a new operator?

It depends on the scope of the job and the equipment it needs. The schedule is set once the site survey is done and the proposal is approved.

How long does a gate operator last?

Parts carry the manufacturer's warranty, HySecurity operators include a 5-year parts warranty, and Control Services covers its labor for 90 days. A professionally installed and maintained operator can last around 10 years, depending on how many times the gate cycles.

Is there a monthly cost after installation?

That depends on the maintenance agreement you choose. Most properties schedule two visits a year, in spring and fall, and high-security facilities can schedule up to four.

Planning a new system, or need service on one you have?

New gates, access control, and cameras start with a site survey. Gate or system down? Call us and you'll hear back within the hour. We're available 24/7.